3=suppress Installation/Location tag prefix when match drawing-wide Installation/Location default values for reports.1=suppress adding the prefix to TAG for reports.0 or missing= add prefix to TAG when output to reports.1=per wire basis mode (each connected wire gets its own wire number assignment).0 or missing= wire tagging normal mode (wires combined into one wire number assignment).missing or 1= force all entered DESC1-DESC3 values to uppercase.0= allow entered DESC1-DESC3 to be upper/lower case.3= mode is on and include Installation/Location as a tag prefix."+" followed by comma-delimited list of project description line numbers that are included as a header in reports. 0 or entry omitted = use component-specific only.2= use MISC_CAT if component-specific table not found.1=always use MISC_CAT for catalog lookup.0 or entry omitted = all options are off.4’s bit set = Suppress Installation/Location codes when match the drawing defaults mode is on.2’s bit set = peer to peer cross-referencing mode is on.1’s bit set = automatic/real-time cross-referencing mode is on.It can be a full path or just the icon menu file name itself (such as ACE_PANEL_MENU.DAT). "+" prefix followed by the icon file name. Note: The variable, %SL_DIR%, is used to indicate the default library path used during installation or as defined in the wd.env file.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |